Builder Gel - Blushing Bride #016

15ml Builder Gel

In stock

15ml Builder Gel

More Information
Write Your Own Review
You're reviewing:Builder Gel - Blushing Bride #016
Your Rating
Ask Your Question
Jot us a note and we’ll get back to you as quickly as possible.

1 Item

Show per page
  1. Vieldah asks 22 Jun 2020

    Hi I just wanted to know dies your builder gels only come in 15ml ?

    1 answer
    1. Beverly Kruger answers 29 Jun 2020

      At the moment the Builder Gel is only available in 15ml jars.

      5 people found this answer helpful.

    2. Only registered users can write comments. Please Sign in or Create an account

1 Item

Show per page


  1. Prepare the nails, apply tips (if using tips) and remove the shine from the tip with a buffer block.

  2. Remove all debris and dust with a dusting brush and wipe with sanitiser.

  3. Apply a very thin layer of CRYSTAL CLAWZ Base Gel from cuticle to free edge, covering the entire nail. Cure for 30 seconds LED or 2 Min UV.

  4. Pick up a large bead of Crystal Clawz Builder Gel. Slowly set it down in the centre of the cuticle area about 5-6mm away from the cuticles. DON’T apply any pressure yet, you are NOT going to brush this gel on. You are going to allow it to freely drop or drizzle off of your brush (as if icing a cake). Start to apply pressure near the free edge (end of nail) to tail off the log of gel. Don’t panic! It will look
    ridiculous. Allow time for it to self level.

  5. Allow to self-level

  6. Using a detail liner brush, spread the gel to the cuticles and sidewalls, making sure that you do not get the product on the skin or cuticles.  If this happens, clean off skin and cuticles before curing as this can cause lifting of the product.

  7. The client’s hand can be turned upside down to allow the gel to run back to the apex if it has levelled down too much.  

  8. Make sure you have an even arch (apex) from the cuticle to the end of the nail, and then from side to side (the C-Curve)

  9. Cure under LED lamp for 60 seconds (approx. 3 minutes under a UV lamp)

    *HEAT SPIKE WARNING* All hard Gels (Builder and Rubber Base) will heat up as a result of the chemical reaction in the curing process.  If the client experiences a burning sensation, remove the hand from the lamp, wait a few seconds and reinsert.  This will NOT damage the nail it will only cause discomfort.  The tolerance level will differ between clients

  10. File to desired length and shape; ensuring that the end product is smooth and thin, without any bumps.  Check that you have an even arch (apex) from the cuticle to the end of the nail, and then from side to side (this is called the C-Curve).  Remember – the overlay needs to be thinner at the front and the cuticle.  The edge should be no thicker than a credit card and the cuticle area should be thin enough to blend with the natural nail.

  11. Use Buffer block and buff to smooth the surface.

  12. Remove all dust using your dusting brush and wipe nail using a lint free cotton wipe and sanitiser.

  13. Finish with desired CRYSTAL CLAWZ Top Coat, or apply colour/art before applying Top Coat

Frequently Bought Together