Before using a new
stamping plate, remove the blue protective plastic by peeling it off.
Once it has been removed, it will not stick back on.
Ensure that all equipment is
ready before begining, as stamping polish dries very quickly.
Any polish applied to the nail must be completely dry to avoid smudging
Select an image and brush a fairly thick layer
of stamping polish over approximately half of the design.
Holding the scraper at a 45 degree angle, scrape
the polish across the design. DO NOT press too hard, as this could
result in the polish being too thin and the design uneven.
Using a stamper, pick up polish by pressing down
or rolling the stamper over the image on the stamping plate.
Transfer the design to the nail using either a
rolling motion from one side of the nail to the other or press firmly
Clean stamping plates with nail polish remover
immediately after and in between uses to avoid the build up of dry
polish on the plates. This could affect the design. For stubborn dried
polish, use pure acetone to clean.
We suggest not storing
the plates directly on top of each other as this will cause scratches.
Try wrapping them individually in cling film to protect them.
For best results and clarity,
we highly recommend our Stamping Polish, as it is specially
designed for stamping. NOT ALL nail polishes work.
Frequently Bought Together
Flower Handle Stamping Plates (10 DESIGNS available)