Premium Stainless Steel Stamping Plates (Choose from 24 different plates)

Before using a new stamping plate, remove the blue protective plastic by peeling it off.  Once it has been removed, it will not stick back on.

Ensure that all equipment is ready before begining, as stamping polish dries very quickly.

Any polish applied to the nail must be completely dry to avoid smudging and distorting.

1. Select an image and brush a fairly thick layer of stamping polish over approximately half of the design.
   
2. Holding the scraper at a 45 degree angle, scrape the polish across the design. DO NOT press too hard, as this could result in the polish being too thin and the design uneven.
   
   
3. Using a stamper, pick up polish by pressing down or rolling the stamper over the image on the stamping plate.
   
   
4. Transfer the design to the nail using either a rolling motion from one side of the nail to the other or press firmly straight down.
   
   
5. Clean stamping plates with nail polish remover immediately after and in between uses to avoid the build up of dry polish on the plates. This could affect the design. For stubborn dried polish, use pure acetone to clean.
   

We suggest not storing the plates directly on top of each other as this will cause scratches. Try wrapping them individually in cling film to protect them.

For best results and clarity, we highly  recommend our Stamping Polish, as it is specially designed for stamping. NOT ALL nail polishes work.